HH-60 Jayhawk 600 Size Helicopter Scale Conversion Kit from Roban - RBN-KFUH60CG6

The HH-60 Jayhawk is a multi-mission, twin-engine, medium-range helicopter operated by the United States Coast Guard for search and rescue, law enforcement, military readiness and marine environmental protection missions. The HH-60 is designed to fly a crew of four up to 300 mi (483 km) offshore, hoist up to six additional people on board while remaining on-scene for up to 45 minutes and return to base while maintaining an adequate fuel reserve. This is the 600 size HH-60 Jayhawk version. Designed to take your Chaos 600 or Trex 600ESP torque tube versions* and transform it into a very scale RC version of the full scale helicopter. This kit includes everything you need to install your mechanics, including the 45 degree angle raised tail gearbox specially designed for easy plug-n-play install in the Chaos or Align mechanics.

These 600 scale conversion kits from Roban offer special designed side frames which are designed to offer 2 primary special features. One is to lower the transmission which allows the torque tube to travel thru the lower tail boom of the helicopter which has always been a problem with most military helicopters. Probably the most revolutionary design in scale helicopters, these frames allow the entire mechanical system to be tucked up inside the dog house just like the full scale helicopters.

No more mechanics taking up the entire fuselage area leaving no room for cockpits, rear seats, etc.

Most of the work is done for you. All wood work is installed. Pre-drilled holes for easy install of the landing gear. Standard 600 set up is an 1100 Kv brushless outrunner motor, 80-100 amp ESC and a 6S 22.2V 5000 mAh or higher LiPo battery.

This fuselage can be completed in as little as 4-6 hrs and is intended for the intermediate to advanced builder. No modifications needed when using stock mechanics and stock rotor head.

Features:

• Fully painted fiberglass scale fuselage
• Magnetic cabin lock system for quick and easy access
• Extremely detailed surface and molded panel lines
• Use of 600 standard equipment (6S Battery, 1100Kv motor), fly with your existing parts

Includes:

• Roban HH-60 Jayhawk 600 - Body Kit

Requires:

• 600 Size helicopter kit
• Helicopter flight controller
• Electronic speed control (ESC)
• Battery eliminator circuit (BEC)
• Brushless motor
• Three cyclic servos
• Tail servo
• Two retract servos
• 6 Cell 22.2V 5000 mAh LiPo Battery with EC5 connector
• 8 Channel radio
• 8 Channel receiver